|
Automation: BE-950
Model Small Beam Robot  ECONOMICAL
BEAM ROBOT FOR
PRESSES UNDER
350 TON
The BE-950 simple pick
and place small beam robot is designed for those
applications where a sprue picker could normally do the
job, but increased flexibility of the part release
position is required. Most pickers swing out from the
mold and drop the part from a relatively high position.
Because the BE-950 has a horizontal beam design the arm
can be lowered outside of the press where the part can
be dropped directly onto a belt conveyor or table. This
robot also offers the benefit of multiple drop
locations.
| HAND-HELD
CONTROL FOR FAST, EASY OPERATION |
 The
BE-950 is equipped with an easyto- use hand held
control. Any changes in program sequencing or robot
positioning can be achieved in just a few seconds. The
BE can be adjusted even while it is in full automatic
operation.
This small beam robot can
handle payloads up to 6.6 lbs. The BE is pneumatically
driven on the vertical and kick stroke with an AC
electric drive on the horizontal. For applications
requiring higher speeds, choose the optional servo drive
on the horizontal axis.
A complete change in
end-of-armtooling from the standard mechanical gripper
to vacuum tooling can be made in a matter of minutes
saving you from costly downtime.
- Fast
take-out time
With a 1.5 second take-out time and a 8 second
overall cycle the mold open time is minimal to
accommodate fast cycles.
- Minimum
cycle time
The compact wrist design requires minimum mold
opening to remove parts in less time.
 Flexible
part placement
The 90° wrist rotation allows parts to be placed
directly on the conveyor.- Simple
to operate
Easy-to-use, compact, hand-held control has nine
standard pre-programmed sequences and memory to save
up to 90 additional programs. The control is a
self-diagnostic system that displays error messages
and alarms.
Specifications:
|
